Comet Labs 48-Port 10 Instrukcja Użytkownika Pobierz pdf (Strona 33)

Installation and User Manual

2.4.3 Power, Battery, Transformer, and CLA Charger Module Rack Mounting

The following steps apply to all modules. For simplicity, only Power Module is shown.

Proceed as follows:

1. Attach both front mounting ear brackets to module with supplied screws. (For this step, it is possible to

adjust the position of both front mounting brackets.)

2. Attach rear support brackets to module. These brackets prevent the module from sliding out of the rack.

3. Attach rails together, secure with wing nuts, and finger tighten. (both sides).

4. Attach both rails to rear and front of rack with supplied flathead screws (as shown).

5. Use caution when sliding unit into rack. Temporarily secure unit to rack with thumb screws on front mounting

brackets.

6. Secure rear support brackets to rails.

Figure 2-6: Rack mounting of the Power Module onto the rails.

Installation 2 — 786-86000-00 B01

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 75 76

Brak uwag

Comet Labs 48-Port 10 Instrukcja Użytkownika Strona 33